General Precautions For Installers - CAME VER-PLUS Series Installation Manual

GENERAL PRECAUTIONS FOR INSTALLERS

⚠
CAUTION! Important safety instructions.
Follow all of these instructions. Improper installation can cause serious bodily harm.
Before continuing, also read the general precautions for users.
This product must only be used for its specifi cally intended purpose. Any other use is
dangerous. Came S.P.A. is not liable for any damage caused by improper, wrongful and
unreasonable use. • This manual's product is defi ned by machinery directive 2006/42/
CE as "partly-completed machinery". Partly-completed machinery is a set that almost
constitutes a machine, but which, alone, cannot ensure a clearly defi ned application.
Partly-completed machinery is only destined to be incorporated or assembled to other
machinery or other partly-completed machinery or apparatuses to build machinery that
is regulated by Directive 2006/42/CE. The fi nal installation must be compliant with
European directive 2006/42/CE and current European reference standards • Given these
considerations, all procedures stated in this manual must be exclusively performed by
expert, qualifi ed staff . • Laying the cables, installation and testing must follow state-
of-the-art procedures as dictated by regulations • Before installing the operator, check
that the door is in proper mechanical condition, that it is properly balanced and that it
properly closes: if any of these conditions are not met, do not continue before having met
all safety requirements • Make sure that opening and closing limiters are fi tted • Make
sure the operator is installed onto a sturdy surface that is protected from any collisions •
Make sure that mechanical stops are already installed • If the operator is installed lower
than 2.5 from the ground or from any other access level, fi t any protections and signs
to prevent hazardous situations. • Do not fi t the operator upside down or onto elements
that could yield to its weight. If necessary, add reinforcements to the fastening points •
Do not install unless door is level to the ground • Suitably section off and demarcate the
entire installation site to prevent unauthorized persons from entering the area, especially
minors and children. • Affi x cautionary signs, such as the door plate, wherever needed
and in plain sight • Use proper protections to prevent mechanical hazards when people
are loitering around the machinery's range of action, for example, avoid fi nger crushing
hazards between the drive arm and the mechanical stops when the door is opening, and
so on). • The electrical cables must run through the cable glands and must not touch
any parts that may heat up during operation, such as the motor, transformer, and so
on). • All opening controls must be installed at least 1.85 m from the perimeter of the
garage door's working area, or where they cannot be reached from outside the door. • All
switches in maintained-action mode must be positioned so that the door, the transit areas
and vehicle thru-ways are completely visible, and yet the switches must be also away from
any moving parts • Unless the action is key operated, the control devices must be fi tted,
at least,1.5 mfrom the ground and where they are not accessible to unauthorised persons
• Before handing over to users, check that the system is compliant with the 2006/42/
CEuniformed Machinery Directive.Make sure the settings on the operator are all suitable
and that any safety and protection devices, and also the manual release, work properly. •
Affi x a permanent tag, that describes how to use the manual release mechanism, close
to the mechanism. • Make sure to hand over to the end user, all operating manuals for