Functions Menu - CAME VER-PLUS Series Installation Manual

Functions menu


IMPORTANT! Start programming by fi rst performing the TOTAL STOP (F1) and CALIBRATING TRAVEL
(A3) functions
Only program functions when the operator is stopped.

You can save up to 250 users.
F 1 Total stop [1-2]
F 2 Input [2-CX]
F 3 Input [2-CY]
F 5 Safety test
Maintained
F 6
action
Control mode
F 7
on 2-7
Control mode on
F 8
2-3P
Obstruction
F 9 detection with
motor stopped
NC input – Door stops and excludes any automatic closing; to resume
movement, use the control device. The safety device is inserted into [1-2], if
unused, select 0.
OFF= Deactivated (default) / ON= Activated
NC input – Can associate: C1 = reopening during closing by photocells, C2
= reclosing during opening by photocells, C3 = partial stop, C4 = obstruction
wait, C7 = reopening during closing by sensitive safety-edges, C8 = reclosing
during opening by sensitive safety-edges, r7 = reopening during closing for
8K2 resistive, sensitive safety-edges, r8 = reclosing during opening for 8K2
resistive, sensitive safety-edges.
OFF = Deactivated (default) / C1 / C2 / C3 / C4 / C7 / C8 / r7 / r8

The C3 setting appears only if F19 is active.
NC input – Can associate: C1 = reopening during closing by photocells, C2
= reclosing during opening by photocells, C3 = partial stop, (appears only if
F19 is > 1), C4 = obstruction wait, C7 = reopening during closing by sensitive
safety-edges, C8 = reclosing during opening by sensitive safety-edges, r7
= reopening during closing for 8K2 resistive, sensitive safety-edges, r8 =
reclosing during opening for 8K2 resistive, sensitive safety-edges.
OFF = Deactivated (default) / C1 / C2 / C3 / C4 / C7 / C8 / r7 / r8

The C3 setting appears only if F19 is active.
After every opening or closing command, the board will check whether the
photocells are working properly.
OFF= Deactivated (default) / 1=CX / 2=CY / 4=CX+CY
The door opens and closes by keeping the button pressed. Opening button on
contact 2-3P and closing button on contact 2-7. All other control devices, even
radio-based ones, are excluded.
OFF= Deactivated (default) / ON= Activated
The control device connected to 2-7 performs the step-step command
(open-close-invert), sequential (open-stop-close-stop), only open or only close.
0 = Step-step (default) / 1 = Sequential / 2 = Open / 3 = Close
The control device connected to 2-3P performs a partial opening (1) or comple-
te opening of the door (2).

The partial opening time is adjusted by function F 36.
1 = Partial opening (default) / 2 = Open
The door closed, open or after a total stop, the gear motor stay idle if the safety
devices, that is, the photocells detect an obstruction.
OFF = Deactivated (default) / ON = Activated