Trigger Switch Replacement - Kemppi Flexlite GX Series Operating Manual

3.6 Trigger switch replacement

In normal use, the trigger switch replacement is not a frequent task. However, removing the trigger switch tem-
porarily may be necessary, for example, when using a K5 level Flexlite GX welding gun with other than Kemppi Fast-
mig equipment.
Tools needed:
TX20
1. Remove the screws holding the trigger switch in place.
2. Slide the trigger switch slightly forward (towards the gun welding end) and pull it out.
Do not use excessive force, the trigger switch is still attached with a wiring connection underneath.
© Kemppi
18/49
Flexlite GX
Operating manual - EN
1921390 / 2002