INSTRUMENTS AND CONTROLS
2. - 3. Work equipment control levers
NOTE
For the details of proportional control switch see "6.5 PREPA-
q
RATION FOR EQUIPMENT INSTALLATION (only for machines
with proportional controls)".
Before carrying out any manoeuvre with these levers, the
q
operator must seat in the work position and fasten the seat
belt.
Before leaving the driver seat, lower the equipment to the
q
ground, lock the controls with the safety lever and stop the
engine.
IMPORTANT
The horn push button is positioned on the right lever grip
q
and must be used to warn all the people in the vicinity be-
fore starting work and in case of danger.
When the safety lever is in the "locked" position, all the
q
movements are inhibited (see "3.2.3 pos: 1. Safety lever
(control locking lever)").
The control lever (2) is positioned on the operator's left and con-
trols the arm and the turret swing.
Swing function
q
(a) Swing to the right
(b) Swing to the left
Arm
q
(c) Fold
(d) Extend
N (Neutral): the turret and the arm are held in the position where
they stopped.
92
WARNING
WEAM012405
RKA22550
RKA01440
RKA01440
RKA16230