Table of Contents
Advertisement
PREPARATION FOR EQUIPMENT INSTALLATION (only for machines with proportional controls)
1.
Quick coupler (1st attachment)
The quick coupling is used to connect the pipes equipped with
quick coupling to the ends of the equipment.
The components used for quick coupler (1st attachment) are:
A
Cap, male (for piping on left side of arm)
B
Cap, female (for piping on right side of arm)
C
Piping on left side of arm (hole end)
D
Piping on right side of arm (shaft end)
NOTE
• When the tools are removed, fit the cap (A) in the quick coupling.
When the tools are fitted, remove the cap (A) and clean the quick coupling carefully before connecting the
q
hoses.
2.
Equipment (2nd attachment)
The components used for attachment (2nd line) are:
A
Cap, female (for piping on right side of arm)
B
Cap, female (for piping on left side of arm)
C
Piping on right side of arm (shaft end)
D
Piping on left side of arm (shaft end)
NOTE
• When the attachments are removed, fit the cap on the hose.
When the attachments are fitted, remove the cap and clean the hose carefully before connecting the hoses.
q
262
FASTER NV 1/2 GAS F CAP (G1/2M)
FASTER NV 1/2 GAS M CAP (G1/2F)
FASTER NV 1/2 GAS F
FASTER NV 1/2 GAS M
9-16 ORFS
9-16 ORFS
9-16 ORFS
9-16 ORFS
WEAM012405
RKA62980
Advertisement
Table of Contents
