Table of Contents
Advertisement
USE OF THE MACHINE AND RELATED CONTROLS
3.
Operate the right work equipment control lever (3) slowly,
stop the bucket, and hold it in the stop position for 5 minutes.
4.
After carrying out the warming-up operations, make sure that
the warning lights and gauges are in the conditions described
below. If any anomaly is observed, carry out the necessary
maintenance operations and repairs.
• Engine coolant temperature warning light (4): warning light
off
• Fuel gauge (5): indicator in the correct position
• Engine oil pressure warning light (6): warning light off
• Battery charge level warning light (7): warning light off
5.
Make sure that the colour of the exhaust gases is normal and
that there are no strange noises or vibrations. If any anomaly
is observed, contact your Komatsu Distributor.
6.
Shift the safety lever (2) to the "locked" position (L), then
make sure that the machine does not move even when the
levers and pedals are operated.
1) The work equipment and the swing must be inhibited
even when the left and right control levers are operated.
2) The machine must not move even if the travel levers are
operated.
3) In this condition it should not be possible to use the blade
or to adjust the track gauge, not even by operating the
blade/adjustable track gauge lever.
4) The boom swing must be inhibited even when the boom
swing control pedal is operated.
134
WEAM012405
RKA10840
RKA26600
RKA22930
Advertisement
Table of Contents
