Table of Contents
Advertisement
During the loading and unloading operations, always use ramps or a platform and proceed as indicated below.
LOADING THE MACHINE
NOTE
Load and unload the machine on/from the trailer on firm and
q
level ground only, and widen the track gauge.
Keep a safety distance from the edge of the road.
1.
Firmly engage the trailer brakes and place the wedges (1)
under the wheel to prevent it from moving.
Place the ramps at the right and left sides (2) in such a way
q
that they are parallel and there is the same distance from
the centre (3) of the trailer. The installation angle (4) must
be 15° max.
If the ramps bend excessively under the
weight of the machine, put blocks (5) under the ramps.
Run the engine at low speed.
2.
(A): Idling
3.
Make sure that the travel speed increase warning light is off.
NOTE
If the warning light is on, press the speed selection switch to the
q
low speed position (B).
WEAM012405
TRANSPORTING THE MACHINE
RKA27170
B
RKA16490
RKA26650
165
Advertisement
Table of Contents
