Table of Contents
Advertisement
5.
Blade/adjustable track gauge selection switch
(if provided)
Use the narrow track gauge only when it is necessary to go
q
through narrow passages or when there is no other choice.
For normal applications and digging operations, always se-
lect the wide track gauge.
Avoid adjusting the track gauge when the machine is work-
q
ing on a slope: the machine may lose stability and over-
turn. Always adjust the track gauge on level surfaces.
When the track gauge is narrowed completely, also the lat-
q
eral stability of the machine is reduced. In work sites where
the machine runs the risk of overturning, always widen the
track gauge and pay the utmost attention during travel.
Before using the blade/adjustable track gauge lever, check
q
the position of the switch.
This is a two-position switch and allows the operator to choose
between using the blade and adjusting the track gauge.
Adjustable track gauge (A):when the switch is in this position, it
Blade (B): When the switch is in this position, it is possible to use
the blade.
For further details on how to use the blade and adjust the track
gauge, (see "3.2.3 pos: 5. Blade/adjustable track gauge lever (if
provided)").
6.
Power outlet
A power outlet is positioned on the front part of the machine for
the connection of a lamp for routine and maintenance operations.
It is a two-pole outlet and is in compliance with the ISO 4165-
1979 standard. Power supply 12 V.
Only use this socket when engine is running.
WARNING
is possible to adjust the track gauge.
WEAM012405
INSTRUMENTS AND CONTROLS
A
B
RYA17100
RKA26560
RKAB5940
87
Advertisement
Table of Contents
