Table of Contents
Advertisement
USE OF THE MACHINE AND RELATED CONTROLS
CHECKING THE ENGINE OIL LEVEL AND TOPPING UP
Soon after the machine has been stopped the engine is very hot and may cause burns; let the engine
q
cool down to 40-45°C before carrying out any check.
When carrying out an inspection or maintenance operation inside the engine hood, always open it com-
q
pletely and make sure that it is kept open by the apposite rod.
NOTE
If the machine is inclined, position it horizontally before carrying out the check.
q
If the engine has just been stopped, before checking the engine oil level wait approximately 15 minutes, in order
q
to allow the engine to cool down.
1.
Open the engine hood. For details, see paragraph "3.2.6 EN-
GINE HOOD"
2.
Remove the dipstick (G) and wipe it with a cloth.
3.
Insert the dipstick (G) completely into the oil filler pipe, then
remove it and check the oil level.
4.
The oil level must be included between the H and L marks; if
the level is near the L mark, top up through the filler neck (F),
using oil suitable for the ambient temperature, as indicated in
the lubricant chart
(see "4.4 FUEL, COOLANT AND LUBRICANTS").
5.
If the oil level is above the H mark, drain the excess oil
through the drain plug (P), and check the oil level again.
6.
If the oil level is correct, tighten the oil filler, then close the en-
gine hood.
118
WARNING
CAUTION
WEAM012405
Advertisement
Table of Contents
