Table of Contents
Advertisement
TRANSPORTING THE MACHINE
4.
Position the work equipment at the front and the blade at the
rear, with the turret and the undercarriage parallel to each
other.
5.
Move the machine towards the ramps and lower the work
equipment as much as possible, taking care to prevent them
from touching the trailer.
6.
Make sure that the machine is in line with the ramps and that
the centerline of the machine corresponds to the centerline of
the trailer.
7.
Load the machine on the trailer or on the truck in the
specified position, operating the travel levers slowly.
When the machine is on the ramps, do not operate any lever
apart from the travel levers.
8.
Stop the machine at the specified point, then swing the turret
by 180°.
SECURING THE MACHINE ON THE MEANS OF TRANSPORT
After positioning the machine on the trailer, it is necessary to secure it by proceeding as indicated below.
IMPORTANT
To avoid damaging the machine during transport, place
q
wooden blocks under the end of the bucket cylinder, in
such a way as to prevent it from touching the ground.
Method of securing the machine with blade anchorage point
1.
Lower the blade.
2.
Extend the bucket cylinder and the arm cylinder completely,
and lower the boom slowly.
3.
Stop the engine and remove the ignition key.
166
WEAM012405
Advertisement
Table of Contents
