Connector Check And Replacement Check - Toshiba TECRA 9100 Series Maintenance Manual

2 Troubleshooting Procedures
Procedure 2

Connector Check and Replacement Check

The Modem is installed as a modem daughter card (MDC). If the modem malfunctions, there
may be a bad connection between the MDC and the system board. Or the MDC, I/O board or
their connectors might be damaged.
Disassemble the computer following the steps described in Chapter 4, Replacement
Procedures and perform the following checks:
Check 1 Make sure the MDC cable is firmly connected to PJ125 on the I/O board and
make sure the MDC is firmly connected to PJ126 on the I/O board.
RJ-11
If a connector is disconnected, connect it firmly and repeat Procedure 1. If the
Modem is still not functioning properly, perform Check 2.
Check 2 The MDC may be defective or damaged. Replace it with a new one following the
steps in Chapter 4, Replacement Procedures. If the modem is still not functioning
properly, perform Check 3.
Check 3 The system board may be defective or damaged. Replace the System Board with a
new one following the steps in Chapter 4, Replacement Procedures.
2-46
PJ124 MDC Board
Modem Jack cable
TECRA 9100 Maintenance Manual (960-347)
2.11 Modem Troubleshooting
PJ125 I/O Board