Installing The Wireless Lan Card - Toshiba TECRA 9100 Series Maintenance Manual

4 Replacement Procedures

Installing the Wireless LAN Card

To install the wireless LAN card (option), make sure that the computer is in boot mode and
powered off, follow the steps below and refer to figures 4-18 and 4-19.
CAUTION: Be sure to switch the computer off before removing the wireless LAN card.
Otherwise, the computer or the wireless LAN card may be damaged.
1. Insert the wireless LAN card into the connector at an angle of 45 degrees.
2. Gently push the wireless LAN card down until latches on both sides engage the
wireless LAN card to hold it in place.
3. Connect the wireless LAN antennas (black and white) cables to the connectors on
the wireless LAN card.
CAUTION: Be careful not to damage or pinch the wireless LAN cables when you seat the
slot cover.
4. Place the wireless LAN card slot cover back on.
5. Secure the cover with one M2×4 flat-head screw.
CAUTION: There are two MAC address barcode labels in the package containing the
new Wireless LAN Card. Apply one label to the bottom of the computer and one to the box
the computer was shipped in. Before you apply the new labels, remove the old ones from
the computer and the box. The computer may have MAC address barcode labels for both
wired and wireless LANs. Be sure to replace the correct label.
4-32
4.7 Wireless LAN Card
TECRA 9100 Maintenance Manual (960-347)