Lan Troubleshooting; Procedure 1 Diagnostic Test Program Execution Check; Procedure 2 Connector Check And Replacement Check - Toshiba TECRA 9100 Series Maintenance Manual

2.13 Bluetooth Troubleshooting

2.12 LAN Troubleshooting

This section describes how to determine if the computer's LAN is functioning properly.
Perform the steps below starting with Procedure 1 and continuing with the other procedures
as required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
The Sound/LAN/Modem test program is stored in the Diagnostics Disk.
For the test, prepare a test Sound/LAN/Modem.
Then insert the Diagnostics Disk in the computer's floppy disk drive, turn on the computer
and run the test. Refer to Chapter 3, Tests and Diagnostics, for more information about the
diagnostics test procedures.
If any errors occur while executing the Sound/LAN/Modem test, go to Procedure 2.
Procedure 2 Connector Check and Replacement Check
An RJ45 jack with LAN cable is connected to the System Board. If the LAN malfunctions,
the System Board might be damaged.
Disassemble the computer following the steps described in Chapter 4, Replacement
Procedures.
TECRA 9100 Maintenance Manual (960-347)
2 Troubleshooting Procedures
2-47