Toshiba TECRA 9100 Series Maintenance Manual page 326

4 Replacement Procedures
5. Secure the ground wire with one strip of tape.
6. Make sure the LCD panel fits into the panel guide ribs.
7. Hook the U-shaped side of the top frame to the P-chassis, then lay the top frame on
the LCD module.
8. Secure the top frame with two latches on the lamp side.
9. Secure five screws on the side of the top frame. Make sure two latches on the lamp
side of the top frame secure the top frame firmly.
Screws
4-114
Latches
Figure 4-86 Installing the top frame
Latches
Tighten the screws with 0.1176N⋅m (1.2kgf⋅cm) of torque.
Figure 4-87 Securing the screws
4.28 FL (Model 14.1 SXGA+ Sharp)
U-shaped side of the top frame
TECRA 9100 Maintenance Manual (960-347)
Screws