A1.4 Ribbon - Toshiba TEC B-852-TS12-QQ Owner's Manual

APPENDIX 1 SPECIFICATIONS

A1.4 Ribbon

Please make sure that the ribbon being used is approved by TOSHIBA TEC. The warranty does not apply to any
problem caused by using non-approved ribbons.
For information regarding TOSHIBA TEC approved ribbon, please contact a sales representative.
Type
Width
Length
Outside Diameter
The table below shows the correlation between ribbon width and media width (backing paper is not included).
Ribbon width
120 mm
160 mm
220 mm
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified ribbons.
2. Use of media with a rough surface may cause ribbon smudges when using ribbon save issue.
3. To avoid ribbon wrinkles use a ribbon which is wider than the media by 10 mm or more. However, too much
difference in width between the two may cause wrinkles.
4. Be sure to use 220 mm-wide ribbon when using media that is 210 to 242 mm wide.
Spool type
120 – 220 mm
Recommended width is 120, 160 and 220 mm.
300 m
72 mm (max.)
Media width
70 – 110 mm
110 – 150 mm
150 – 242 mm
A1- 5
EO1-33029
A1.4 Ribbon