Inserting The Optional Pcmcia Cards - Toshiba TEC B-852-TS12-QQ Owner's Manual

2. PRINTER SETUP
2.10 Inserting the
Optional PCMCIA
Cards
CAUTION!
1. To protect PC cards,
discharge static
electricity from your body
by touching the metal
cabinet of the printer
before touching the card.
2. Before inserting or
removing a PCMCIA
card make sure that the
printer's power is turned
off.
3. Be sure to protect
PCMCIA Cards when not
in use by putting them
into their protective
covers.
4. Do not subject the card
to any shocks or
excessive force nor
expose the card to
extremes in temperature
or humidity
5. The card may be
inserted into the slot
halfway even in the
wrong orientation.
However, the slot is
safety designed so that
the card will not seat
against the connector
pins.
When the optional PCMCIA interface board is installed into the B-852
printer, there will be two PCMCIA slots available as shown in the figure
below. This allows for the use of Flash Memory Type Cards or I/O type
Cards such as LAN Cards. The following paragraphs outline how to
insert PCMCIA cards.
1. Make sure that the printer's power switch is in the OFF position.
2. Hold the PCMCIA Card so that the model name printed side faces
right. Insert the card into the proper slot until the Eject Button pops
out.
Model Name Printed Side
3.
The following PCMCIA cards can be used.
Type Maker
San Disk
ATA Card
Hitachi
LAN Card 3 COM
Flash
Memory Maxell
Card (4 MB)
2-14

2.10 Inserting the Optional PCMCIA Cards

Slot 0:
(Memory type cards only)
Slot 1:
(I/O type cards such as
LAN cards)
Eject Button
Description
A card conforming to
the PC card ATA
standard
Install into the slot
Ether Link III (1) only. (This card
3C589D PC card installed into the slot
(0) will not work.)
CC
EF-4M-TB
DC
EF-4M-TB
EO1-33029
Remarks
----------
----------