Toshiba TEC B-852-TS12-QQ Owner's Manual page 95

APPENDIX 4 SYSTEM MODE
A4.5 Test Print (Cont.)
Print Sample of Slant Line
(1 dot)
Print Sample of Slant Line
(3 dots)
NOTE:
See A4.11.3 for further
information.
Test Print Pattern Selection
When "<4>TEST PRINT" appears after paper feed selection, press the
[PAUSE] key.
Select a test print pattern from the following options.
[RESTART]
[FEED]
Slant Line (1 dot)
While selecting the Slant Line (1 dot), press the [PAUSE] key to start
printing the slant line patterns (1 dot). After printing is completed, the
display returns to "<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to show "SLANT LINE
(1DOT)" again. Then, press the [FEED] key.
Slant Line (3 dots)
While selecting the Slant Line (3 dots), press the [PAUSE] key to start
printing the slant line patterns (3 dots). After printing is completed, the
display returns to "<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to show "SLANT LINE
(3DOT)" again. Then, press the [FEED] key.
A4-17
EO1-33029
A4.5 Test Print