Testing Tab - Toshiba TEC B-852-TS12-QQ Owner's Manual

3. PRINTER OPERATION
3.4.9 Options Tab (Cont.)
CAUTION!
Be careful not to set the
print density adjustment
too high as it can
shorten the life of the
print head. This also
may cause ribbon
tearing if set too high in
thermal transfer mode.

3.4.10 Testing Tab

Print Density Adjustment - Clicking on the Set: check box is
necessary to enable the print density adjustment from this property
page. If not checked then no adjustment is possible. When this box is
checked, the screen appears as below.
Print density can be set separately for direct thermal and for thermal
transfer modes. Click on the increase/decrease arrows to adjust the print
density between -10 and +10 in increments of 1.0
This page will allow the execution of certain diagnostic tests and some
additional maintenance settings. When clicking on the Testing tab, the
following screen display will appear.
3-29
3.4 Using the B-852 Printer Properties Menus
EO1-33029