Toshiba TEC B-852-TS12-QQ Owner's Manual page 20

2. PRINTER SETUP
2.7.3 Loading Media into the
Printer (Cont.)
WARNING!
The Print Head may
become hot. Do not
touch the Print Head.
Risk of injuries. Do not
touch moving parts.
Disconnect the mains
before maintenance of
ribbon and media.
CAUTION!
Be careful not touch the
Print Head Element when
raising the Print Head
Block. Failure to do this
may cause missing dots
by static electricity or
other print quality
problems.
2. Release the Print Head Block by pressing down on the Head Block
Release Lever
3. Raise the Print Head Block to its fully open position as shown by the
arrow in the diagram below.
Print Head Block
4. Release the Paper Guide Locking Levers on the two Paper Guides as
shown in the figure below.
5. Grasp the right hand Paper Guide and move it to the right to open the
Paper Guides wide enough to accept the media.
6. Feed the media between the two guides.
7. Feed the paper under the Upper Sensor Ass'y and pull the paper until
it extends past the Platen. (until it extends past the cutter outlet when
the optional Cutter Module is attached.)
8. Grasp the right Paper Guide and move it to the left to close both Paper
Guides and automatically center the media.
9. Press the Paper Guide Locking Levers to lock the Paper Guides in
place.
Paper Guide
Lock
Paper Guide
Locking Lever
2-10
as shown below.
2
1
Free
Platen
EO1-33029
2.7 Loading the Media
Print Head
Element
Head Block
Release Lever
Paper Guide
Upper Sensor
Ass'y