Toshiba TEC B-852-TS12-QQ Owner's Manual page 89

APPENDIX 4 SYSTEM MODE
A4.4 Printer Parameter
Fine Adjustment
(Cont.)
NOTES:
The fine adjustment value
equals the sum of the fine
adjustment values set by the
PC command and this
parameter. The maximum
ribbon motor voltage fine
adjustment value is +6 and
15 (Rewind Motor) or +10
and –15 (Feed Motor).
When the value reaches the
maximum, the value
remains unchanged even if
the subsequent fine
adjustment is performed.
One step corresponds to 5%
of the standard voltage and
up to 75% of the voltage
can be decreased. Only for
the feed motor, the voltage
can be increased up to 50%.
Please make this adjustment
if a ribbon error occurs
though the ribbon is not
jammed nor depleted.
If the problem cannot be
resolved, please contact
your nearest TOSHIBA TEC
service representative.
Ribbon Motor Voltage Fine Adjustment (Feed/Rewind Motor)
With this parameter you can fine adjust the Ribbon Motor Voltage
(Torque). When "<3>ADJUST SET" appears, press the [PAUSE] key
7 times to enter the Ribbon Motor Voltage Fine Adjustment (Rewind
Motor) menu.
To change the screen to the Ribbon Motor Voltage Fine Adjustment
(Feed Motor), press the [PAUSE] key again.
[RESTART]
[FEED]
[FEED] key: Pressing the [FEED] key one time causes a –1 step change,
up to –15 steps.
[RESTART]key: Pressing the [RESTART] key one time causes a +1
tone change, up to +0 steps (Rewind Motor) or +10 steps (Feed Motor).
After completing the fine adjustment, press the [PAUSE] key.
A4-11
A4.4 Printer Parameter Fine Adjustment
Rewind Motor
Feed Motor
Rewind Motor
EO1-33029
Feed Motor