Toshiba TEC B-852-TS12-QQ Owner's Manual page 103

APPENDIX 4 SYSTEM MODE
A4.7.1 Self-Diagnostic Test Result Sample and Descriptions (Cont.)
(8) Sensor 1 Check
The status of the Cutter Home Position Sensor, Ribbon Feed Motor Sensor, and Ribbon Rewind Motor
Sensor are printed.
SENSOR1
Fixed to 0.
Ribbon feed motor sensor 2 status
0: The detecting point is positioned
outside the slit.
1: The detection point is positioned
inside the slit.
Cutter home position switch
Ribbon rewind motor sensor 1
Ribbon feed motor sensors 1 and 2
(9) Sensor 2 Check
The status of the Print Head Thermistor, Environmental Temperature Thermistor, Heat Sink Thermistor,
Black Mark Sensor (Upper/Lower), and Feed Gap Sensor are printed.
SENSOR2 [H]20 C [A]22 C [S]25 C [R(U)]3.3V [R(L)]4.0V [T]2.4V
0 0 0 0 0 0 0 0 , 0 1 1 1 0 0 1 1
Fixed to 0.
Sensor/Switch
Environmental thermistor status:
0 - 86 C
If it is undetectable, "-- C " is printed.
Print head thermistor status:
0 C - 86 C
Fixed to 1.
Fixed to 1.
Cutter home position switch status
0: Home position
1: Other position
Fixed to 0.
Ribbon rewind motor sensor 1 status
0: The detecting point is positioned outside the slit.
1: The detecting point is positioned inside the slit.
Ribbon feed motor sensor 1status
0: The detecting point is positioned outside the slit.
1: The detecting point is positioned inside the slit.
Print status content description
Indicates whether or not the cutter is at the home
position.
Controls ribbon motor rotation by detecting the slit on
the ribbon rewind motor and the ribbon feed motor.
Indicates the position of the slit sensor.
Black mark sensor (Upper) status:
0.0 – 5.0V
Heat sink thermistor status:
25 C, 80 C, 90 C
A4-25
A4.7 Additional Information
Feed gap sensor status:
0.0 – 5.0V
Black mark sensor (Lower) status:
0.0 – 5.0V
EO1-33029