Toshiba TEC B-852-TS12-QQ Owner's Manual page 29

3. PRINTER OPERATION
3.2 Operating Modes
(Cont.)
CAUTION!
Be sure to cut the
backing paper of label.
Cutting labels will cause
the glue to stick to the
cutter, which may affect
the cutter quality and
shorten the cutter life.
Use of tag paper when
the thickness exceeds
the specified value may
affect the cutter life.
NOTE:
Cut mode is available only when
the optional cutter module
(B-7208-QM) is installed.
2. Continuous (or batch) mode – In this mode, the labels will be
continuously printed and fed until the number of labels specified in
the label issue command has been printed. After the last label of the
series has been printed the labels can be torn free from the supply roll
in a similar manner as described in the tear off mode above.
3. Cut Mode - In the cut mode, as each label is printed it is fed forward
to the cutter mechanism where the swing cutter mechanism will
precisely cut the label off from the supply roll. The feed mechanism
will then backfeed the label or card stock until it is properly positioned
under the print head to print the next label in series. The issue
command sent to the printer from the Host can inform the printer to
cut each label or tag after each has been printed or to perform the cut
only after a certain number of labels or tags have been printed and
issued.
3- 2
EO1-33029
3.2 Operating Modes