Toshiba TEC B-852-TS12-QQ Owner's Manual page 92

APPENDIX 4 SYSTEM MODE
A4.5 Test Print (Cont.)
NOTES:
When pressing the [FEED]
and [RESTART] keys at
the same time in the Test
Print menu, the message
returns to "<4>TEST
PRINT".
If holding the [FEED] or
[RESTART] key for 0.5
seconds or longer in the
Test Print menu, the key is
entered continuously.
The fine adjustment
parameters are effective for
the Test Print. (except for X
Axis Fine Adjustment.)
If any error occurs, an
error message appears, and
the printer stops printing.
After clearing the errors,
press the [PAUSE] key to
return to the System Mode
menu. The printer does not
resume printing
automatically.
A changed parameter
becomes enabled by
pressing the [PAUSE] key
and is stored in memory
until the printer is turned
off.
While pressing the [FEED] and [PAUSE] keys at the same time, turn
on the printer. Hold both keys until the "<1>DIAG. Vx.x" Message
appears.
Press the [FEED] key 2 times.
The Test Print is ready to be performed.
Specifying the Print Condition for the Test Print
The print conditions for the Test Print should be specified before
printing. When "<4>TEST PRINT" appears, press the [PAUSE] key.
Issue Count Setting
To enter the Issue Count Setting menu, press the [PAUSE] key.
[RESTART]
[FEED]
After selecting the issue count, press the [PAUSE] key to go to Print
Speed Setting.
A4-14
EO1-33029
A4.5 Test Print