3. The power wiring between the DC power supply and the switch must be stranded copper wire within the
range of 10 to 24 AWG.
2.8 Reset Button
The reset button is used to perform a reset to the switch. It is not used in normal cases and can be used for
diagnostic purpose. If any network hanging problem is suspected, it is useful to push the button to reset the
switch without turning off the power. Check whether the network is recovered.
The button can also be used to restore the software configuration settings to factory default values. The
operations are:
Operation
Press the button for more than five seconds until
all LEDs blink. Then, release button.
Press the button and release during switch operation
Function
Restore factory default settings &
reboot the switch.
Re-boot the switch unit
-23-