KTI Networks KGS-2422-TG Series Installation Manual page 35

IP Address Configuration
Select [Configuration] -> [System] -> [IP] to configure IP address for VLAN 1
Configuration
IPv4 DHCP
Enable
Fallback
Current Lease
Address
Mask Length
Save
Reset
Description
DHCP client configuration
Enable the DHCP client by checking this box. If this option is enabled, the system
will configure the IPv4 address and mask of the interface using the DHCP protocol.
The number of seconds for trying to obtain a DHCP lease. After this period expires, a
configured IPv4 address will be used as IPv4 interface address. A value of zero
disables the fallback mechanism, such that DHCP will keep retrying until a valid
lease is obtained. Legal values are 0 to 4294967295 seconds.
For DHCP interfaces with an active lease, this column shows the current interface
address, as provided by the DHCP server.
The IPv4 address of the interface in dotted decimal notation. If DHCP is enabled, this
field configures the fallback address. The field may be left blank if IPv4 operation on
the interface is not desired - or no DHCP fallback address is desired.
The IPv4 network mask, in number of bits (prefix length). Valid values are between 0
and 30 bits for a IPv4 address. If DHCP is enabled, this field configures the fallback
address network mask. The field may be left blank if IPv4 operation on the interface
is not desired - or no DHCP fallback address is desired.
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
-35-