Cis Type Setting - Brother ADS-1000W Service Manual

1.3.9 CIS type setting

<Function>
This function sets CIS type as EEPROM parameter of the main PCB.
Note:
• If the CIS type is set, be sure to install the firmware. The parameters of the CIS type are
set by installing the firmware after the CIS type setting.
<Operating Procedure>
(1) Connect the machine to your computer using the USB cable in the initial state of
maintenance mode.
(2) Turn ON the computer.
(3) Open the temporary folder and double-click "Filedg32.exe" to start it, and select the
"Brother Maintenance USB Printer".
(4) Drag and drop the "CDSM59-1-3-1_FS.pjl" file in the temporary folder onto the "Brother
maintenance USB Printer" icon. CIS type setting is completed. If the firmware is not the D
version or later, after drag and drop, the CIS type is not be completed with a beep.
5-7
Confidential