Install Firmware From Usb Flash Memory Drive - Brother ADS-1000W Service Manual

1.3.10 Install firmware from USB flash memory drive

<Function>
This function is used to install firmware stored in the flash ROM mounted on the main PCB
using USB flash memory drive.
<Operating Procedure>
(1) Create a folder in the top hierarchy of USB flash memory drive and name it "Brother".
(2) Save main firmware (LZ****.pjl) to the "Brother" folder created in USB flash memory drive.
Note:
• Before saving the firmware to the USB flash memory drive, check if the file name
with extension ".pjl" is for the model to be installed with the firmware. If "Brother"
folder has multiple firmware files, it fails to specify the execution file, resulting in
update failure due to invalid operation.
(3) Connect the USB flash memory drive with firmware file to the machine in the initial state of
maintenance mode.
(4) Press the [to Network Device1] key, and then [to Network Device2] key twice. The to PC
and to USB LEDs light.
(5) Press the
installation.
(6) When the firmware is successfully installed, the
to the ready state.
Note:
• LEDs indicate errors as below. In case of error, press the
to the initial state of maintenance mode.
LED
key. All LEDs start flashing in turns, and the machine starts firmware
Media is used in other operation.
USB flash memory drive is not connected.
"Brother" folder cannot be found.
LED flashes and the machine returns
key to return the machine
Description
5-8
Confidential