Checking Firmware Version - Brother ADS-1000W Service Manual

1.1

Checking Firmware Version

Check whether the firmware installed on the main PCB is the D version or later. If it is the D
version or later, there is no need to install the firmware. If it is not, be sure to install the firmware
to the main PCB as described in
<How to check firmware version>
(1) Press and hold the
state. LEDs except WiFi LED light.
(2) Press the [to USB], [to Network Device2], and [to Network Device1] keys in this order. The
to USB, Error,
(3) Press the [to Network Device2] key. All LEDs go out.
(4) Press the [to Network Device2] key again. The to Network Device2 LED lights.
(5) Press the
(6) Turn ON the computer.
(7) Connect the computer to the machine with the USB cable.
(8) Double-click "brmfrmss.exe" that was copied into the temporary folder to start remote
check mode. The screen shown below appears.
(9) Click the [Machine Info.] tab. The firmware version is displayed.
"1.4 Installing Firmware"
key for five seconds or longer when the machine is in the ready
, and LEDs light and the machine enters the maintenance mode.
key.
in this chapter.
4-2
Confidential