3Di/Lc Module - Siemens SIMATIC ET 200SP System Manual

To connect the assembly, mount the server module after the last BaseUnit.
Note
Server module
You can find out how to assemble/disassemble the server module in chapter "Installing the
server module (Page 79)".
Note
Removing the motor starter
You will find out how to remove the motor starter in chapter "Replacing a motor starter
(Page 239)".
6.14.3

3DI/LC module

Introduction
The optional 3DI/LC module with three inputs and one further LC input can be connected to
the motor starter. The status of the inputs of the 3DI/LC module can be seen via the process
image input (PII) of the motor starter.
Note
The 3DI/LC module can be used for the motor starter and the fail-safe motor starter.
The input actions can be parameterized. For reasons of operational safety, the LC input is
permanently set to manual local mode. For example, by parameterizing the inputs DI1 - DI3
with motor CLOCKWISE or motor COUNTER-CLOCKWISE, you can control the motor in
manual local mode.
The figure below shows the 3DI/LC module.
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
6.14 Mounting/disassembly of motor starters
Wiring
121