Installation; Operation - SunStar SPS/D-BH-6000 Series User Manual

2) Installation

Caution

3) Operation

Warning
Depending on installation environments, functional errors, breakdown and other
physical damages could occur to the machine. The following conditions shall be
satisfied for the installation:
ⓐ Please unwrap the machine package starting from the top to the bottom in order.
In particular, pay special attention to the nails on the edges in case where the
package is a wooden box.
ⓑ Install an air conditioner and clean the machine regularly since dust and moisture
can pollute and rust the machine.
ⓒ Install the machine in a place where it is not exposed to direct sunlight. The long-
term exposure to direct sunlight could cause discoloration or deformation.
ⓓ Place the machine at least 50cm away from the left, right, front and back walls to
secure sufficient space for maintenance.
[Note] Please refer to
4. Installation of the Machine
installation.
The SPS/D-BH6000 Series are made for industrial use to carry out pattern sewing for
textiles and other similar materials. Please observe the following guidelines when
operating the machine.
ⓐ Please read this manual thoroughly and have a clear understanding before
operation.
ⓑ Wear proper clothes for safe machine operation
ⓒ During operation, do not make your hands or parts of your body close to the
operating parts of the machine (needle, nook, thread take-up, pulley, etc.).
ⓓ Do not remove any of safety plates and various covers during operation.
ⓔ Grounding system must be connected.
ⓕ Shut off the electric power supply and make sure the power switch is off before
opening the power box including control box.
ⓖ Make sure of stopping the machine before inserting a thread through a needle or
examining the machine after sewing.
ⓗ Do not turn on the machine with putting a foot on the pedal.
ⓘ Do not plug multiple motors into one electric outlet.
ⓙ Grounding system must be connected.
ⓚ Place the machine away as far as possible from noise generated sources including
high-frequency welding machine.
, for more information on machine
7