Adjust The Gap Between Holes - SunStar SPS/D-BH-6000 Series User Manual

C. Insert the transfer pin① into the hole which indicates the
original position of the cloth transfer bar.
D. Turn the bolt② to make it meet with the cloth transfer
bar④.
E. Tighten the nut③ to fix the bolt②.
F. Check whether the transfer pin① smoothly slides into
the original point after the cloth transfer bar touches the
bolt.

6) Adjust the gap between holes

A. Loosen the bolt①.
B. Push the cloth transfer bar② until it touches the stopper bolt①.
C. Move the transfer movement block④ to make sure of the smooth entering of the transfer pin③ into the indexer hole.
D. Make the stopper block⑤ touch the transfer movement block④ and tighten the bolt⑥ with the nut.
⑥
①
50
⑤
② ④
③
③
①
②
④
Baseline Location
38.1mm
44.45mm
50.8mm
[ Fig. 13 ]
[ Fig. 14 ]