6) Adjust needle guard
A. Loosen screw① and adjust the position of the needle
guard②.
B. Until the end of the looper③ touches the needle④, the
needle④ shall not move against the needle guard②.
7) Adjust the position of spreader
A. Loosen the screw③ and adjust the spreader stopper (left)④ to make the fork of the spreader(left) ① meet the lower
thread guide hole of the looper(left)②.
B. Loosen the screw⑦ to make the both ends of the spreader (right)⑤ and the looper (right)⑥ located at the same place,
and adjust the position of the spreader stopper(right)⑧.
①
④
③
②
③
④
⑥
⑦
③
①
②
[ Fig. 33 ]
⑤
⑧
⑦
[ Fig. 34 ]
29