Honeywell SmartVFD HVAC MR4 User Manual page 81

Honeywell
• 9
2.3.3 Local/remote control button
The LOC/REM button is used for two functions: to quickly access the Control page and to easily
change between the Local (Keypad) and Remote control places.
2.3.3.1 Changing the control place
The control place is the source of control where the drive can be started and stopped.
In the HVAC drive, the
The Remote control place
Change of control place from
1. Anywhere in the menu structure, push the
2. Push the Arrow up
OK button.
3. On the next display, select
4. The display will return to the same location as it was when the
pushed.
STOP READY
Main Menu
ID: M1

Monitor
( 7 )
Parameters

( 15 )

Diagnostics
( 6 )
STOP READY
Main Menu
ID: M1

Monitor
( 7 )
Parameters

( 15 )

Diagnostics
( 6 )
Local control place
is determined by parameter M1.15 (I/O or Fieldbus).
Remote to Local
or the Arrow down
Local Remote
or
STOP Ready
Keypad
ID:1805 ID:
Change direction
LOC
REM
I/O
is always the keypad.
(keypad).
Loc/Rem button.
button to select Local/Remote
and again confirm with the
Keypad
Choose action
Control page
OK
Local/Remote
G -
RAPHIC KEYPAD INTRODUCTION
and confirm with the
OK
button.
Loc/Rem button was
STOP READY Keypad
?
Local/Remote
ID: ID:211
Local
Remote Remote
OK