Honeywell SmartVFD HVAC MR4 User Manual page 116

HVAC A
PPLICATION
3.5.7.3 Digital outputs, slot B (Basic)
Code Parameter
M3.5.3.2.1 Basic R01 function
M3.5.3.2.2 Basic R01 ON delay
M3.5.3.2.3 Basic R01 OFF delay
M3.5.3.2.4 Basic R02 function
M3.5.3.2.5 Basic R02 ON delay
M3.5.3.2.6 Basic R02 OFF delay
M3.5.3.2.7 Basic R03 function
Table 29. Digital output settings on basic I/O board
Min Max Unit
0 35
0.00 320.00 s
0.00 320.00 s
0 35
0.00 320.00 s
0.00 320.00 s
0 35
Default ID
Function selection for Basic
R01:
0 = None
1 = Ready
2 = Run
3 = General fault
4 = General fault inverted
5 = General alarm
6 = Reversed
7 = At speed
8 = Motor regulator active
9 = Preset speed active
10 = Keypad control active
11 = I/O B control activated
12 = Limit supervision 1
13 = Limit supervision 2
14 = Start signal active
15 = Reserved
16 = Fire Mode activation
17 = RTC time chnl 1 control
2 11001 18 = RTC time chnl 2 control
19 = RTC time chnl 3 control
20 = FB ControlWord B13
21 = FB ControlWord B14
22 = FB ControlWord B15
23 = PID1 in Sleep mode
24 = Reserved
25 = PID1 supervision limits
26 = PID2 supervision limits
27 = Motor 1 control
28 = Motor 2 control
29 = Motor 3 control
30 = Motor 4 control
31 = Reserved (Always
open)
32 = Reserved (Always
open)
33 = Reserved (Always
open)
34 = Maintenance alarm
35 = Maintenance fault
0.00 11002 ON delay for relay
0.00 11003 OFF delay for relay
3 11004 See M3.5.3.2.1
0.00 11005 See M3.5.3.2.2.
0.00 11006 See M3.5.3.2.3.
See M3.5.3.2.1.
1 11007 Not visible if only 2 output
relays are installed
Honeywell • 44
Description