Sc211 Control Unit - Becker M Installation Manual

SC211 control unit

Commissioning of the SC211 awning radio-controlled
movement sensor
1. Programming the master
transmitter
Switch off the power supply on the
radio receiver (drive type PSF(+))
and then switch it back on
the programming button on the
SWC241-II master transmitter
the drive clicks twice
Note: Follow the instructions on
pages 92 and 93 to set the limit
positions for the PSF(+) drive.
2. Programming the SC211
a.) Remove the labelling field on the
back of the SWC241-II radio hand-
held transmitter. Use the tool pro-
vided to turn the SWC241-II wind
threshold regulator clockwise to
the maximum setting
press the programming button
until the drive clicks once
b) Then press the red programming
button of the SC211 until the
tubular drive clicks once
c) Press the red programming
button again
drive clicks twice
. Press
until
.
. Then
.
.
until the tubular
.
144
2x click
1x click
1x click
2x click