SWS241 control set
Commissioning the SWS241 radio-controlled
Sun-Wind-Set hand-held transmitter with sensor
1. Programming the master
transmitter
a. Run the shading solution to a
centre position using the UP/
STOP/DOWN toggle switch.
b. Press the programming button
on the SWC510. The SWC510
goes
into
the
mode for 3 minutes.
c. When in the programming mode,
press the programming button
on the SWC441 hand-held radio
transmitter until a confirmation
(the shading solution shifts) is
received.
Note: In order to recognise the
shift clearly, the shading solution
should be situated between the
limit positions.
programming
140