Install The Pto Shaft - Krone Swadro TC 680 Original Operating Instructions

Pos: 44.39 /Überschriften/Überschriften 2/F-J/Gelenkwelle montieren @ 2\mod_1202398342788_78.docx @ 59253 @ 2 @ 1
9.6

Install the PTO shaft

Pos: 44.40 /BA/Sicherheit/Gelenkwelle/Gefahr - Sich drehende Gelenkwelle_2 @ 0\mod_1199781692950_78.docx @ 34523 @ 2 @ 1
Danger! - Rotating PTO shaft
Effect: Danger to life or serious injuries
• Install or detach the PTO shaft only with the engine switched off and the ignition key
removed.
• Secure the tractor against rolling.
• Make sure that the PTO shaft is coupled properly (the lock of the PTO shaft must have
snapped in).
• Make sure that the protective devices are attached properly.
• Never use a PTO shaft, the protective devices of which have not been attached.
• Replace damaged protective devices immediately
• Attach the safety chain of the PTO shaft so that the guard tube does not rotate
simultaneously with the PTO shaft.
Pos: 44.41 /BA/Sicherheit/Gelenkwelle/Gefahr - Antriebsdrehzahl 540 beachten @ 3\mod_1205316518245_78.docx @ 73595 @ @ 1
Danger! - Observe drive speed
Effect: Danger to life or serious injuries
• This machine is driven at a maximum PTO speed of 540 rpm.
Pos: 44.42 /BA/Inbetriebnahme/Schwader/Anbau Gelenkwelle/Anbau Gelenkwelle Bild SW 700#_800# @ 134\mod_1350458386270_78.docx @ 1186264 @ @ 1
2
Fig. 17
Pos: 44.43 /BA/Inbetriebnahme/Schwader/Anbau Gelenkwelle/Anbau Gelenkwelle angehängte Schwader Text @ 37\mod_1263463772393_78.docx @ 339645 @ 22 @ 1
• Switch off the engine and remove the ignition key.
• Install the PTO shaft (1) on the machine side (wide angle on machine side).
• Rotate the PTO shaft support (2) upwards.
• Then slide PTO shaft onto the PTO of the tractor. In doing this, ensure that the sliding pin is
securely engaged.
• Secure the PTO shaft guard against turning with the retaining chain (3).
Pos: 44.44 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ 2 @ 1
3
1
3
Start-up
1
SW700083
41