VESPA GTS Super 125 i.e. Service Station Manual page 208

Suspensions
Shock absorber lower fitting 40 ÷ 45 Upper shock absorber fixing screws 20 ÷ 25 Nm
Exhaust bracket
Removal
Remove the full muffler unit.
- Remove the two fixing screws of the bracket to
the engine crankcase
- Remove the split pin, the cover and the fixing nut
of the rear wheel axle and its spacer
- Remove the shock absorber lower clamp
Refitting
- The refitting procedure is in the reverse order of the removal operation being careful to respect the
torques indicated and the spacer assembly layout as shown in the photo.
Locking torques (N*m)
Bracket fixing screws to the engine crankcase: 20 ÷ 25 Shock absorber lower fitting 40 ÷ 45
Wheel axle clamping 104 ÷ 126
Centre-stand
REMOVAL
- Use a jack to support the vehicle properly.
- Remove the two return springs from the centre
stand.
- Undo the nut shown in the figure.
- Remove the pin from the right side.
- Remove the centre stand.
FITTING
- On refitting tighten the nut to the specified torque.
Locking torques (N*m)
Centre stand bolt
32 to 40
SUSP - 208
Vespa GTS Super 125 i.e.