Checking Led Indications - ADC Modem MM701G User Manual

Checking LED Indications

C LED I
HECKING
Your service provider sets up the G.shdsl parameters for your service. The MM701G must have
the DSL SYNC LED lit before you can connect sessions with your service provider. Verify
SYNC in the following table.
The table below describes LED indications for all operational modes. LEDs on the MM701G
front panel provide continual status at-a-glance for network and voice connections.
LED State
POWER On green
Off
LINK On green
Off
Tx Flashing green
Off
Rx Flashing green
Off
Coll Flashing green
Off
Sync On green
Flashing green
Off
Tx Flashing green
Off
Rx Flashing green
Off
Margin On green
Off
6
NDICATIONS
Description
MM701G has power.
MM701G does not have power.
Ethernet
A PC, hub, or other network device is connected to the MM701G
10Base-T interface.
No device is connected to the MM701G 10Base-T interface.
MM701G is transmitting data to devices on the LAN.
MM701G is not transmitting data to the LAN.
MM701G is receiving data from devices on the LAN.
MM701G is not receiving data from the LAN.
Ethernet packet collisions are occurring on the LAN.
No Ethernet packet collisions are occurring.
DSL
DSL transceiver is synchronized (connected) and in normal operation
mode.
Slow flashing green indicates that the DSL transceiver is in a start-up
or handshaking sequence. Fast flashing green indicates that the DSL
transceiver is in training sequence.
DSL transceiver is not detecting a transceiver at the far end and is not
connected.
MM701G is transmitting data over the DSL connection.
MM701G is not transmitting data over the DSL connection.
MM701G is receiving data over the DSL connection.
MM701G is not receiving data over the DSL connection.
DSL margin is above the preset margin value.
DSL margin is at or below the preset margin value.
MM701G User Manual