ADC Modem MM701G User Manual page 59

SHDSL Parameter
UpFrameSync
UpStuffBits
DownFrameSync
DownStuffBits
Encoder CoeffA
Encoder CoeffB
MinBaseRate
MaxBaseRate
MinSubRate
MaxSubRate
WirePairMode
AsymmetricPSD
BitRateMode
TestBitRate
SNRMarginLimit
MM701G User Manual
Chapter 4: Managing the Modem Using the Console Port & Telnet
Description
The Upstream Frame Sync Word parameter.
(Default: 13727)
The Upstream Stuffbits parameter. (Default: 15)
The Downstream Frame Sync Word parameter.
(Default: 13727)
The Downstream Stuffbits parameter. (Default: 15)
The encoder coefficient for the A channel. (Default: 366)
The encoder coefficient for the B channel. (Default: 817)
Used with the MinSubRate to define the minimum line
rate. (Default: 1)
Used with the MaxSubRate to define the maximum line
rate. (Default: 36)
Used with the MinBaseRate to define the minimum line
rate. (Default: 0)
Used with the MaxBaseRate to define the maximum line
rate. (Default: 1)
Currently only SinglePair is supported.
Select between the three options: Symmetric PSD,
AsymPSDHighRate, AsymPSDLowRate.
(Default: SymmetricPSD)
The method in which the modem establishes a bit rate
with the device on the other side of the DSL line (such as
the DSLAM or another MM701G). Fixed Rate attempts to
establish a connection only at the rate that is specified
while Adaptive Rate dynamically negotiates its bit rate.
(Default: Adaptive Rate)
Select a value from 72K to 2320K. (Default: 2320)
The signal-to-noise ratio limit. This can be set between
-64 to +63. The Margin LED on the front panel indicates
when the actual SNR is greater than the configured value.
(Default: 4)
Values
0 to 65535
0 to 16
0 to 65535
0 to 16
0 to 1048577
0 to 1048577
1 to 36
0,1
0,1
SinglePair, TwoPair
SymmetricPSD,
AsymPSDHighRate,
AsymPSDLowRate
Fixed Rate, Adaptive
Rate
72K to 2320K
-64 to 63
53