ADC Modem MM701G User Manual page 38

Managing DSL
2 Configure the following parameters as supplied by your service provider:
Parameter
Exec Mode
Standard
Startup Margin
Power Backoff
Clock Offset
Upstream Frame Sync Word
Upstream Stuffbits
Downstream Frame Sync Word
Downstream Stuffbits
Encoder Coefficient A
Encoder Coefficient B
Minimum Base Rate
Maximum Base Rate
Minimum Sub Rate
Maximum Sub Rate
Wire Pair Mode
Asymmetric PSD
Bit Rate Mode
Test Bit Rate
SNR Margin Limit
3 Click Apply, then save changes using
32
Description
Select CPE or CO. For point-to-point connections, one modem must
be configured for CPE and the other for CO. For all other applications,
select CPE.
Select Annex A or Annex B (Default: Annex A). Annex A and Annex B
are both transmission standards. Annex A is most often used in North
America. Annex B is most often used in Europe.
Select a value from 2 DB to 15 DB. Applies only to Rate-Adaptive mode
(Default: 2 DB).
Select Enable or Disable (Default: Enable).
Do not change from factory-ship configuration.
Do not change from factory-ship configuration.
Do not change from factory-ship configuration.
Do not change from factory-ship configuration.
Do not change from factory-ship configuration.
Do not change from factory-ship configuration.
Do not change from factory-ship configuration.
Enter a value from 1 to 36 to select the minimum acceptable data rate
in Rate-Adaptive mode. Rate is equal to N*64kbps, where N is the
selected value (Default: 1).
Enter a value from 1 to 36 to select the maximum acceptable data rate
in Rate-Adaptive mode. Rate is equal to N*64kbps, where N is the
selected value (Default: 36).
Enter 0 or 1 (Default: 0).
Enter 0 or 1 (Default: 1).
Select Single or Two (Default: Single).
Select Disabled, 1544 kb, or 784 kb (Default: Disabled).
Select Adaptive Rate or Fixed Rate (Default: Adaptive Rate).
Select a value from 72K to 2368K (Default: 2320K).
Enter a value from -64 to 63. Used to control the front panel LED.
(Default: 4).
"Saving Changes" on page 38.
MM701G User Manual