Table of Contents
Advertisement
Valid values for the parameters shown on the LAN Setup screen are defined in the following
table.
LAN Parameter
LAN Protocol
IP address
IP Net Mask
Default Gateway
DHCP
DHCP Range Low Address
DHCP Range High Address
DHCP Gateway Address
DHCP DNS
Apply
Setting Up DHCP
This procedure is optional. Follow this procedure to enable or disable DHCP on the modem.
From the Main Menu, select
parameters:
1
To enable DHCP, select
Setup menu. If
disables DHCP.
2
Enter the low range of the DHCP IP addresses as supplied by your LAN administrator.
3
Enter the high range of the DHCP IP addresses as supplied by your LAN administrator.
4
Enter the default gateway address that is provided to the requesting DHCP client—only if
you are operating in server mode. This IP Address is also available from your LAN
administrator.
5
Enter the DNS address that is provided to the requesting DHCP client—only if you are
operating in server mode. This IP Address is also available from your LAN administrator.
MM701G User Manual
Chapter 4: Managing the Modem Using the Console Port & Telnet
Valid parameter Values
Router or Bridge.
IP address assigned by your LAN administrator, or DHCP
server (Default 10.0.0.1).
IP address assigned by your LAN administrator, or DHCP
server (Default 255.255.255.0).
Default Gateway provided by your access provider.
Client, Server, or None.
DHCP low range IP address supplied by your LAN
administrator.
DHCP high range IP address supplied by your LAN
administrator.
In DHCP Server Mode, this is the gateway address that is
automatically assigned to the requesting DHCP client.
In DHCP Server Mode, this is the DNS address that is
automatically assigned to the requesting DHCP client.
Apply Settings.
LAN Setup
screen and enter values for the following DHCP
DHCP
and choose either
DHCP Client
is selected, you do not need to configure an IP address.
Client
or
Server
by typing
2
or
3
on the LAN
None
49
Advertisement
Table of Contents
