Table of Contents
Advertisement
Configuring the LAN
2
Configure the following parameters:
Parameter
LAN Protocol
IP Address
Subnet Mask
Default Gateway
DHCP
DHCP Range Low
DHCP Range High
28
Description
Select the message format to be used for your LAN.
• Select Bridge if the LAN forwards packets based on MAC addresses. If you
selected RFC 1483 Bridge protocol for the WAN sessions
for the LAN traffic.
• Select Router if the LAN routes packets based on IP addresses. If you selected
RFC 1483 Router or PPP protocol for the WAN sessions
for the LAN traffic.
See your LAN administrator for LAN IP addresses.
However, if you want to change the IP address through the Web interface, enter an
IP address for the LAN (10Base-T) port provided by the LAN administrator. Or, you
can use the default IP address for the LAN port which is 10.0.0.1. If you choose to
use the default IP address, ensure that the devices on your LAN are on the same
subnet as the MM701G LAN port.
If you select Client for the DHCP configuration (below in this table), a DHCP server
on your LAN automatically provides the IP address.
Enter the subnet mask for the LAN (10Base-T) port provided by the LAN
administrator. Or, you can use the default subnet mask for the LAN port which is
255.255.255.0. If you choose to use the default subnet mask, ensure that it allows
devices on your LAN to access the MM701G LAN port.
Enter the default IP address for a default gateway that is supplied by the service
provider.
See your LAN administrator for the DHCP selection. You selected whether or not you
wanted to enable DHCP in
However, if you want to change that DHCP selection through the Web interface,
select one of the following:
• None—DHCP is not enabled.
• Client—The MM701G is a DHCP client and can be served an IP address for the
LAN port by a DHCP server on your LAN.
• Server—The MM701G is a DHCP server and can serve IP addresses to devices
on your LAN. See DHCP Range Low and High for the ranges of IP addresses that
the MM701G can serve.
Enter the IP address supplied by your LAN administrator. This is the lowest IP
address value that the MM701G can serve when configured as a DHCP server.
Enter the IP address supplied by your LAN administrator. This is the highest IP
address value that the MM701G can serve when configured as a DHCP server.
"Determining IP Addresses" on page
(page
23), select Bridge
(page
23), select Router
14.
MM701G User Manual
Advertisement
Table of Contents
