Table of Contents
Advertisement
Setting Up the WAN
2
Select a session by typing the session number at the
display the
WAN Session Options
Session Parameters
1. Session Name
2. WAN Protocol
3. State
4. IP Addressing
5. IP Address
6. IP Net Mask
7. NAT
8. RIP Send
9. RIP Accept
3
Type
10
to select the VPI parameter, then enter the values supplied by your service
provider.
4
Type
11
to select the VCI parameters, then enter the values supplied by your service
provider.
5
If you are operating in Router mode, you also need to enter the WAN ADSL Port ID
address and the associated WAN IP subnet mask. Both of these values are provided by your
service provider.
6
Select
Apply
to activate your changes.
made for this session.
7
Select
Save New System configuration
Current Configuration" on page 60
46
screen.
Bridge
RFC1483 Bridge
Enabled
N/A
N/A
N/A
N/A
N/A
N/A
Select parameter to edit (Return to exit) ->
or the changes will be lost upon reboot or power cycle.
Select session for editing prompt
10. VPI
11. VCI
12. QOS
13. QOS Peak Cell Rate
14. Encapsulation
15. Login Name
16. Login Password
17. Authentication
18. Apply
Apply
immediately activates the changes that you have
from the Main Menu as described in
0
35
UBR
LLC
N/A
N/A
N/A
"Saving the
MM701G User Manual
to
Advertisement
Table of Contents
