Table of Contents
Advertisement
Step 6: Mount the NBP 1200C to the Table
Insert the NBP 1200C enclosure into the table
CAUTION:
The flanged edges of the top
of the surface enclosure are sharp.
These edges are also soft and may be
easily nicked or bent. Exercise caution
when handling the enclosure to prevent
personal injury or damage to the
enclosure.
ATTENTION :
Les extrémités à brides
du haut de la surface du boîtier sont
aiguisées. Ces extrémités sont aussi
lisses et peuvent facilement être
coupées ou pliées. Soyez prudents
lorsque vous manipulez le boîtier afin
d'éviter de l'endommager ou de vous
blesser.
Under the table, adjust the side clamps on the enclosure
Lever
1
Rotate the side clamp
outward and ensure
that the lever is down.
Securing the Cable Cubby Enclosure
Figure 7.
1
Remove the plastic
plastic
strips and lm on
m on
the surface of the
f the
Cable Cubby.
2
Ensure that the
side clamps are
e
seated against
the enclosure.
Inserting the NBP 1200C Enclosure into the Table
Figure 6.
1
1
2
Slide the clamp all the
way up against the
bottom of the table.
NOTE:
To lower the side clamp, turn the lever
down, then press and hold the locking plate
while sliding down the clamp.
Locking
plate
3
Ensure the Cable Cubby
is rmly seated in the table.
Raise the lever to secure
the Cable Cubby.
3
Lower the Cable Cubby
into the hole to test the t.
If necessary, carefully
enlarge the opening.
7
Advertisement
Table of Contents
