Retractor Bracket - Extron electronics NBP 1200C Setup Manual

Step 4: Install Modules and a Retractor Bracket
Determine where the modules are to be installed in the Cable Cubby. Any combination of two modules can be installed. The
modules can be installed on either side of the enclosure and at various heights.
NOTES:
Ensure that there is enough room above the modules for the Cable Cubby lid to close completely.
•
Use a screwdriver to secure the modules with the screws.
•

Retractor bracket

Use the retractor bracket to mount cable retractors in the
Cable Cubby enclosure. The retractor bracket
accommodates up to three Retractor Series/2 or
Retractor Series/2 XL cable retraction modules.
The retractors must be purchased separately. Visit
www.extron.com to find available retractor models,
retractor filler modules, and optional retractor brackets.
If you require retractors, insert the retractor bracket as
shown in figure 4.
NOTE:
Do not mount the retractors in the retractor
bracket until after the Cable Cubby is mounted (see
Step 7: Install Retractors
Install retractor filler modules in any unused retractor
mounting spaces.
Optional retractor brackets each accommodate two
cable retraction modules. These brackets must be
purchased separately. They are sold in pairs and allow
the cable retractors to be mounted at the outer edges
of the enclosure with one of the other modules mounted
centrally.
AAP module, cable pass-through module and power module
Insert the modules into the cable cubby as shown in figure 5.
NOTES:
Extron recommends mounting the power module
•
on the left side of the enclosure.
For any cables that must be connected to
•
modules, feed them up through the table or other
furniture before attaching them to each module.
AC power and AC+USB power modules are available for
US, Europe, and other major world markets. They must be
purchased separately (see www.extron.com).
Most AC power modules provide two unswitched AC
outlets.
The AC+USB power modules provide one or two AC outlets
and two USB power outlets.
WARNING:
Risk of Electric Shock. To ensure proper
electrical grounding, use the provided #6-32
mounting screws with the star washers.
AVERTISSEMENT :
Risque de choc électrique. Afin
d'assurer une mise à la terre correcte, utilisez les
fixations de mise à la terre #6-32 et les rondelles en
étoile fournies.
on page 8.)
Figure 4. Installing the Retractor Bracket
Figure 5. Installing the Connectivity and Power Modules
2
Secure the bracket
using four of the provided
pan-head mounting
screws with star washers.
Tighten the screws using
a screwdriver.
1
Insert the bracket as shown.
The bracket may be installed
on the left or right side of the
enclosure and at the
lowest height.
1
Insert the modules
into the Cable Cubby.
2
Secure the modules
using four of the
provided pan-head
mounting screws
and star washers.
5