Extron electronics NBP 1200C Setup Manual page 14

NBP 1200C • Setup Guide (Continued)
Overall Configuration Procedure
Cable the NBPs and the control processor or HCR receiver,
Within Global Configurator
(GC Professional or
GC Plus mode):
Create a new GC Professional or GC Plus project
Add NBP button panels and con gure the buttons.
Overall Configuration Steps
Figure 15.
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
14
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
Get ready.
Prepare the installation site.
Change buttons or faceplates, if desired
then apply power.
Configure the IP settings of each NBP
and of the control processor or receiver.
If desired or required, install a new
security certi cate (via Toolbelt).
and add the control processor or receiver to it.
Con gure ports.
Create monitors, schedules, timers, macros,
and local variables.
Save the project.
Build and upload the con guration to
the controller or receiver.
Cable all devices.
Test the system, make adjustments,
nalize con guration.
Mount the NBPs.
on the Extron website.
© 2019 Extron Electronics All rights reserved.
All trademarks mentioned are the property of their respective owners.
See the network network
communication communication
setup instructions
setup instructions
on page 10.
www.extron.com
68-3267-53, Rev. A
12 19