Extron electronics NBP 1200C Setup Manual page 9

Step 9: Cable the NBP 1200C and Other Devices in the System
Run a network cable to the NBP 1200C.
1.
Connect the NBP to the network via the LAN/PoE port on the bottom panel of the NBP 1200C (shown in figure 11).
2.
NBP 1200C Bottom Panel
NBP 1200C
RESET
Reset
LED and Button
Figure 11. NBP 1200C Bottom Panel Features
Details of LAN/PoE port connection, LED behavior, protocol, addresses, and credentials are shown in figure 12.
NBP
Bottom Panel
Activity LED:
Blinks
amber to
indicate data
is being sent
LAN/PoE
or received.
Ethernet
TCP/IP
PC Network
Figure 12. NBP 1200C LAN/PoE Port Details
IMPORTANT NOTES:
The factory configured password for this device has been set to the device serial number. Passwords are case
•
sensitive. Performing a Reset to Factory Defaults (see
password to extron.
DHCP is off by default.
•
Cable devices to the control processor or HCR receiver (see the user guide for the appropriate device), and connect the
3.
control processor or HCR receiver to the same network as the NBP.
Connect power cords and power on the control processor or receiver and other devices.
4.
00-05-A6-XX-XX-XX
MAC: 00-05-A6-XX-XX-XX
S/N: XXXXXXX EXXXXXX
MAC Address
Connector and LEDs
Label
Link LED: Lights
Connect to an Ethernet network.
green to indicate a
This port must be con gured.
network connection.
Default protocol:
• NBP address: 192.168.254.253
• Gateway IP address: 0.0.0.0
• Subnet mask: 255.255.255.0
• DNS address: 127.0.0.1
• DHCP: off
• Link speed and duplex level: autodetected
• Data rates: 10/100Base-T
RJ-45
Connector
Power over Ethernet (PoE):
The NBP receives power at this port.
Default login credentials:
• Username: admin
• Initial password: unit serial number
• Password after a "Reset to Factory
Defaults": extron
NOTE:
(00-05-A6-XX-XX-XX) is located
on the bottom panel, next to the
LAN port.
00-05-A6-XX-XX-XX
MAC: 00-05-A6-XX-XX-XX
S/N: XXXXXXX EXXXXXX
Extron
Control
MAC: 00-05-A6-XX-XX-XX
Processor S/N: XXXXXXX EXXXXXX
LAN/PoE
LAN/PoE (Ethernet)
LAN/PoE (Ethernet and
Power Over Ethernet)
MAC address information
MAC
Address
Reset Modes: a Brief Summary
ATTENTION:
Power over Ethernet (PoE) is
•
intended for indoor use only.
It is to be connected only
to networks or circuits that
are not routed to the outside
plant or building.
L'alimentation via Ethernet
•
(PoE) est destinée à une
utilisation en intérieur
uniquement. Elle doit être
connectée seulement à des
réseaux ou des circuits qui ne
sont pas routés au réseau ou
au bâtiment extérieur.
on page 12) sets the
9