Procedure - Nortel 1000 Installation And Commissioning Manual

a. Use two #8-32 machine screws. Position the ear bracket so the four
holes on the bracket flange are closer to the rear of the Media
Gateway.
Note: To determine the front of the bracket, locate the "L" on the bracket.
The "L" must be at the top of the bracket and face the front of the Media
Gateway.
WARNING
A Media Gateway or a Media Gateway Expander each
weighs approximately 30 lb. (13.5 kg) with circuit cards
installed and 26 lb. (12 kg) without circuit cards installed.
If necessary, get assistance when lifting the equipment.
5 Place the Media Gateway on the guide brackets.
a. Carefully slide the Media Gateway into the rack until the ear brackets
come to rest against the rack support.
Note: Make sure that the rear of the Media Gateway is on the guide
brackets. See Figure 19 on
6 Use the four remaining #10-32 machine screws to fasten the Media
Gateway to the rack supports (two screws on each side).
Figure 19
Media Gateway installed in a rack
Communication Server 1000E
Rack-mounting the components
page 89.
Use two screws on
each side to fasten
the Media Gateway
End of Procedure
Page 89 of 466
Installation and Commissioning