Nortel 1000 Installation And Commissioning Manual page 187

Connecting an HP DL320-G4 Signaling Server
Figure 60
HP DL320-G4 Signaling Server (rear view)
5 Set the baud rate for the serial port on the Signaling Server to 9 600 b/ps.
See Signaling Server: Installation and Commissioning (NN43001-312).
Note: The IBM X306m Signaling Server ships with the serial port set to
9600 b/ps.
6 Configure the connected maintenance terminal. See Signaling Server:
Installation and Commissioning (NN43001-312).
7 Press the Power switch.
Note: Refer to the Signaling Server Product Guide on the CD-ROM
shipped with the IBM X306m Signaling Server for additional operating
information.
In geographic regions that are susceptible to electrical storms, Nortel
recommends that you plug the HP DL320-G4 Signaling Server into an AC
surge suppressor.
Figure 60 shows the rear view of the HP DL320-G4 Signaling Server.
Communication Server 1000E
Installing a Signaling Server
End of Procedure
Installation and Commissioning
Page 187 of 466